diff --git a/locales/en/messages.json b/locales/en/messages.json
index 9840a1ae..541c1f1c 100644
--- a/locales/en/messages.json
+++ b/locales/en/messages.json
@@ -2125,7 +2125,7 @@
         "message": "Please do <span class=\"message-negative\">not</span> try to flash <strong>non-Betaflight</strong> hardware with this firmware flasher.<br />Do <span class=\"message-negative\">not</span> <strong>disconnect</strong> the board or <strong>turn off</strong> your computer while flashing.<br /><br /><strong>Note: </strong>STM32 bootloader is stored in ROM, it cannot be bricked.<br /><strong>Note: </strong><span class=\"message-negative\">Auto-Connect</span> is always disabled while you are inside firmware flasher.<br /><strong>Note: </strong>Make sure you have a backup; some upgrades/downgrades will wipe your configuration.<br /><strong>Note:</strong> If you have problems flashing <strong>try disconnecting all cables from your FC</strong> first, try rebooting, upgrade chrome, upgrade drivers.<br /><strong>Note:</strong> When flashing boards that have directly connected USB sockets (most newer boards) ensure you have read the USB Flashing section of the Betaflight manual and have the correct software and drivers installed"
     },
     "firmwareFlasherRecoveryHead": {
-        "message": "<strong>Recovery / Lost communication<strong>"
+        "message": "<strong>Recovery / Lost communication</strong>"
     },
     "firmwareFlasherRecoveryText": {
         "message": "If you have lost communication with your board follow these steps to restore communication: <ul><li>Power off</li><li>Enable 'No reboot sequence', enable 'Full chip erase'.</li><li>Jumper the BOOT pins or hold BOOT button.</li><li>Power on (activity LED will NOT flash if done correctly).</li><li>Install all STM32 drivers and Zadig if required (see <a href=\"https://github.com/betaflight/betaflight/wiki/Installing-Betaflight\"target=\"_blank\">USB Flashing</a> section of Betaflight manual).</li><li>Close configurator, Close all running chrome instances, Close all Chrome apps, Restart Configurator.</li><li>Release BOOT button if your FC has one.</li><li>Flash with correct firmware (using manual baud rate if specified in your FC's manual).</li><li>Power off.</li><li>Remove BOOT jumper.</li><li>Power on (activity LED should flash).</li><li>Connect normally.</li></ul>"