diff --git a/docs/Rssi.md b/docs/Rssi.md
index 882f9e128e..4080d3fff0 100644
--- a/docs/Rssi.md
+++ b/docs/Rssi.md
@@ -24,29 +24,6 @@ set rssi_invert = ON
 ```
 Default is set to "OFF" for normal operation ( 100 = Full signal / 0 = Lost signal).
 
-
-### RSSI_SCALE setup method
-
-To calculate the rssi offset and scale, check the rc value at full signal (`rssi_fullsig`) and at almost no signal strength (`rssi_nosig`).
-Then, calculate the offset and scale values using the following formula:
-
-```
-rssi_offset = 1000-(rssi_nosig) / 10
-rssi_scale = 100 * 1000 * (rssi_fullsig - rssi_nosig)
-```
-
-Examples are:
-
-| RC System | RC value at full strength | RC value at no strength | `rssi_offset` | `rssi_scale` |
-|:----------|:--------------------------|:------------------------|:--------------|:-------------|
-| Graupner  | `1900`                    | `1100`                  | `-10`         | `125`        |
-
-Then set these values via CLI:
-```
-set rssi_offset = -10
-set rssi_scale = 125
-```
-
 ## RSSI via Parallel PWM channel
 
 Connect the RSSI signal to any PWM input channel then set the RSSI channel as you would for RSSI via PPM
@@ -86,3 +63,26 @@ set rssi_invert = ON
 FrSky D4R-II and X8R supported.
 
 The feature can not be used when RX_PARALLEL_PWM is enabled.
+
+
+## RSSI_SCALE setup method
+
+To calculate the rssi offset and scale, check the rc value at full signal (`rssi_fullsig`) and at almost no signal strength (`rssi_nosig`).
+Then, calculate the offset and scale values using the following formula:
+
+```
+rssi_offset = 1000-(rssi_nosig) / 10
+rssi_scale = 100 * 1000 * (rssi_fullsig - rssi_nosig)
+```
+
+Examples are:
+
+| RC System | RC value at full strength | RC value at no strength | `rssi_offset` | `rssi_scale` |
+|:----------|:--------------------------|:------------------------|:--------------|:-------------|
+| Graupner  | `1900`                    | `1100`                  | `-10`         | `125`        |
+
+Then set these values via CLI:
+```
+set rssi_offset = -10
+set rssi_scale = 125
+```