diff --git a/docs/Installation.md b/docs/Installation.md
index a4d0102086..af80e569fa 100644
--- a/docs/Installation.md
+++ b/docs/Installation.md
@@ -1,20 +1,21 @@
 # Installation
 
 ## Using the configurator
-This is a generic procedure to flash a board using the configurator. The configurator does not yet support all boards, so please check the doc that corresponds to your board before proceeding. Check [the docs folder](https://github.com/cleanflight/cleanflight/tree/master/docs) for a file named "Board - xxxx.md" where xxxx is the name of your board.
+This is a generic procedure to flash a board using the configurator. The configurator does not yet support all boards, so please check the docs corresponding to your board before proceeding.
 
-Make sure you have the [cleanflight configurator](https://github.com/cleanflight/cleanflight-configurator) installed, then:
+Make sure you have the [Cleanflight Configurator](https://github.com/cleanflight/cleanflight-configurator) installed, then:
 
 * Connect the flight controller to the PC.
-* Start the cleanflight configurator.
+* Start the Cleanflight Configurator.
 * Click on "Disconnect" if the configurator connected to the board automatically.
 * Click on the "Firmware Flasher" tab.
 * Make sure you have internet connectivity and click on the "Load Firmware [Online]" button.
 * Click on the "Choose a Firmware / Board" dropdown menu, and select the latest stable version for your flight controller.
-* If this is the first time CF is flashed to the board, tick the "Full Chip Erase" checkbox.
-* Connect the flight controller board to the PC.
+* IMPORTANT: Read and understand the release notes that are displayed.  When upgrading review all release notes since your current firmware.
+* If this is the first time Cleanflight is flashed to the board, tick the "Full Chip Erase" checkbox.
+* Connect the flight controller board to the PC.  Ensure the correct serial port is selected.
 * Click on the "Flash Firmware" button and hold still (do not breathe, too).
-* When the top bar becomes green and reads "Programming: SUCCESSFUL" you are done! Disconnect the board and click out of the Firmware Flasher tab.
+* When the progress becomes green and reads "Programming: SUCCESSFUL" you are done!
 
 ## Manually