PLL-HSE working
PLL-HSI working
Move SystemCoreClockUpdate in SystemInit to end
Switching from HSI-PLL to HSE-PLL (and back) is working
It works during various levels of overclocking.
Renamed CLI variable hse_mhz to system_hse_mhz
Restored the original position of the spectrum bind code
The internal logic of the spectrum bind code will prevent binding
process to fire if executed after soft reset.
Remove stale call to delay
Add a comment about call to spektrumBind placement
Declared SystemXXXSource functions, handled sign-ness warning.
Cleaned up commented out sections
USB clock generation for F446
Default HSE value for backward compatibility
Cleaned up more unused stuff
Handle non-F4 targets
Added comment about PLL_M selection
Removed fake gyro/acc from test target
Adds `rc_smoothing_auto_smoothness` parameter that allows the user to tune the filter auto cutoff calculation. Increasing the value makes the resulting rcCommand traces smoother.
Allows the user to retain the "auto" calculation which is important for protocols that can change rate (like CRSF), but still tune the resulting "smoothness" to their preference.
Adds a new `tpa_mode` parameter that accepts `PD` (default) and `D`. Allows the user to configer to affect P/D as it always has, or switch to D-only mode.
Note: the `tpa_mode` parameter was added to the PID Profile instead of rate profiles with the other TPA parameters. This can be discussed, but I didn't think it made sense to have this be part of rate profiles as it affects PID tuning (the same argument could be made for the other TPA parameters).
Code is wrapped in `USE_TPA_MODE` so it can be disabled if needed.
Percentage implementation
Settings fix, formatting
Add support for different number of motors
Optimize and cut superfluous code
Hard-add mixer.h
Formatting adjustment to fit BF standards, linking error in unittest fix attempt
Add stubs and variables for unittests
Character based indicators
Change output to special characters
Fix spacing
Update test code, add variable
Include changes as per peer review
Adds a race start assistance system that allows the pilot to pitch forward and then release the sticks with the quad holding position for the race start.
MCO2 output as run time configurable option
Add sanity check for MCO2 pin
changed output mode to AF from OUTPUT in mco driver
MCO for F4 is not implemented yet
Reinstate original OMNIBUSF7 target.h
Add config variable mco2_on_pc9
Make MCO2 pin hardcoded with mco2_on_pin control variable
fixed mco2 clock config corruption
removed unused pin definitions
