Analyze the rc modes activation conditions and only process configured entries. Previously the entire possible list was processed even though typically only a handful are configured.
Reduces the RX task processing time by about 25% (~44us to ~33us) with an average setup of 3 modes configured (F405, SBUS). Processing time savings will diminish as the user configures more modes. But typically far fewer than the maximum of 20 will be configured.
Previously the initial arming attempt would initiate the gyro calibration but then fail because gyro calibration was underway. The user is confused as they're holding the arming sticks but nothing is happening. This always forced the user to release the arming stick command and then perform a second arming stick command to actually arm.
After the fix the initial arming will proceed as long as the pilot holds the arming stick command through the duration of the gyro calibration (1.25 seconds by default). This seems normal to the user as they're waiting for the motors to start (or at least the arming beeps) before releasing the sticks anyway.
Tries to prevent DSHOT beacon commands from interfering with commands to set the motor direction.
Adds a 2 second delay after disarming before DSHOT beacon commands will be sent. This attempts to prevent the beacon commands from interfering with the motor direction reset that happens after using crash flip mode.
During arming if a DSHOT beacon command has been sent within 2 seconds the arming will be delayed until the 2 seconds have passed. This attempts to prevent interference with the motor direction commands sent at arming.
* Fix for minthrottle when feature 3d and pwm enabled
* add parameters for min and max 3d output
* bug fix
* remove new parameters from msp
* remove new parameters again
* fixed indentation
Addresses the rare possibility that if runway takeoff triggers and disarms while the pilot has the sticks in some valid stick command configuration. Prevents the stick command from processing until the craft is disarmed and the ARMING_DISABLED_RUNAWAY_TAKEOFF condition is cleared.
For example, if the pilot was mid throttle and went full yaw right and runway takeoff triggered, then camera control would have be entered.
Detects runaway pidSum values on takeoff and auto-disarms to prevent the "Tasmanian Devil" caused by incorrect props, wrong motor order/direction, incorrect flight controller orientation, etc. After a successful takeoff and normal flight is detected the feature is disabled for the remainder of the battery.
When FEATURE_3D is on and BOX3DDISABLE is on then the normal throttle
arming check is performed.
When FEATURE_3D is on and BOX3DDISABLE is off then the reduced 3D
throttle arming check is performed.
ADD CAMERA_CONTROL ENTER KEY TO THROTTLE CENTER, YAW HI
ADD CAMERA_CONTROL ENTER KEY TO THROTTLE CENTER, YAW HI
remove Enter key enter using Thr_low Pit_low
