Disarm on crash flip recovery or impact while in do nothing mode
add blackbox headers for new fields
rearrange altitude factors
fix ibus uint16 for estimatedVario
update GPS altitude at 120hz
get GPS derivative from error
PT2 filter on GPS derivative
remove acceleration element
move altitude filtering to position.c
calculate altitude derivative in position.c for vario
filter vario with PT1
update pg in position and baro
field and test tuning from field tests
land 3x faster from higher altitude
PT2 vario for checking GPS
single minimum GPS satellite setting
single required GPS satellite setting
CLI Baro vs GPS trust user interface
GPS trust refactoring
allow arming with GPS_FIX even if not enough sats
required sats must be present to arm
set required sat count to 8
add blackbox headers
convert pressure to altitude early
remove median filter
PT2 filtering upsampled to altitude function in position.c - thanks KarateBrot
baro task synced to position task - thanks Steve
PT2 implementation - thanks KarateBrot
ground altitude from filtered altitude
baro cali by average of calibration samples over cal period
adjust vario and smoothing defaults
don't say haveBaroAlt until cal is complete
reduce PIDs since Baro is faster
add baro smoothing values to blackbox header
Co-Authored-By: Jan Post <post@stud.tu-darmstadt.de>
Co-Authored-By: Steve Evans <SteveCEvans@users.noreply.github.com>
```
+---------+
| FS-iA6B |
| |
| Ser RX |---|<---\ +------------+
| | | | FC |
| Sensor |---[R]--*-------| Uart TX |
+---------+ +------------+
```
R = 10Kohm, Diode 1N4148 or similar.
Both uart tx and rx channels are used so it's not possible to use the spare pin for rx of something else.
Configure the serial port like this to get both serial rx and ibus telemetry on the same port:
```
serial 1 4160 115200 57600 115200 115200
```
It is still possible to run the serial rx and ibus telemetry on two uarts like before, an example:
```
serial 1 64 115200 57600 0 115200
serial 2 4096 115200 57600 115200 115200
```
