mirror of
https://github.com/betaflight/betaflight.git
synced 2025-07-25 17:25:20 +03:00
Open Source Flight Controller Firmware
The STM32F3DISCOVERY board would crash when setting GPIOA Pin_13 or Pin_14 to analog mode so they are excluded in the gpio initialisation. The USART GPIO configuration did not work when using the F10x code. The USART status and DMA registers are different too. |
||
---|---|---|
lib | ||
obj | ||
src | ||
support | ||
.gitignore | ||
baseflight.uvproj | ||
JLinkSettings.ini | ||
Makefile | ||
README.md | ||
startup_stm32f30x_md_gcc.s | ||
stm32_flash.ld |
Cleanflight
Clean-code version of baseflight flight-controller - flight controllers are used to fly multi-rotor craft and fixed wing craft.
This fork differs from baseflight in that it attempts to use modern software development practices which result in:
- greater reliability through code robustness.
- easier maintainance through code cleanliness.
- easier to develop new features.
- easier to re-use code though code de-coupling and modularisation.
The MultiWii software, from which baseflight originated, violates many good software development best-practices. Hopefully this fork will go some way to address them. If you see any bad code in this fork please immediately raise an issue so it can be fixed, or better yet submit a pull request.
Contributing
Before making any contributions, take a note of the https://github.com/multiwii/baseflight/wiki/CodingStyle
For this fork it is also advised to read about clean code, here are some useful links: