diff --git a/docs/Cli.md b/docs/Cli.md
index 4d60d426a3..d6862af789 100644
--- a/docs/Cli.md
+++ b/docs/Cli.md
@@ -187,6 +187,7 @@ Re-apply any new defaults as desired.
 |  nav_fw_launch_spinup_time    | 100 | Time to bring power from min_throttle to nav_fw_launch_thr - to avoid big stress on ESC and large torque from propeller |
 |  nav_fw_launch_timeout  | 5000 | Maximum time for launch sequence to be executed. After this time LAUNCH mode will be turned off and regular flight mode will take over (ms) |
 |  nav_fw_launch_climb_angle  | 18 | Climb angle for launch sequence (degrees), is also restrained by global max_angle_inclination_pit |
+|  nav_fw_land_dive_angle  | 2 | Dive angle that airplane will use during final landing phase. During dive phase, motor is stopped or IDLE and roll controll is locked to 0 degrees |
 |  serialrx_provider  | SPEK1024 | When feature SERIALRX is enabled, this allows connection to several receivers which output data via digital interface resembling serial. See RX section. |
 |  serialrx_halfduplex  | OFF | Allow serial receiver to operate on UART TX pin. With some receivers will allow control and telemetry over a single wire |
 |  sbus_inversion     | OFF | Standard SBUS (Futaba, FrSKY) uses an inverted signal. Some OpenLRS receivers produce a non-inverted SBUS signal. This setting is to support this type of receivers (including modified FrSKY). This only works on supported hardware (mainly F3 based flight controllers). |