mirror of
https://github.com/iNavFlight/inav.git
synced 2025-07-13 19:40:27 +03:00
53 lines
1.6 KiB
Markdown
53 lines
1.6 KiB
Markdown
# Wireless connections
|
|
|
|
From INAV 5 onwards, the Configurator supports wireless connections via Bluetooth Low Energy (BLE) and Wifi (UDP and TCP).
|
|
|
|
## BLE
|
|
|
|
The following adapters are supported:
|
|
|
|
- CC2541 based modules (HM1X, HC08/09)
|
|
- Nordic Semiconductor NRF5340 (Adafruit BLE Shield)
|
|
- SpeedyBee adapter
|
|
|
|
Flightcontrollers with BLE should also work, if you have an adapter/FC that doesn't work, open an issue here on Github and we will add it.
|
|
|
|
### Configuring the BLE modules
|
|
Activate MSP in INAV on a free UART port and set the Bluetooth module to the appropriate baud rate.
|
|
|
|
Example for a HM-10 module:
|
|
|
|
Connect the module to a USB/UART adapter (remember: RX to TX, TX to RX), and connect it to a serial terminal (e.g. from the Arduino IDE),
|
|
Standard baud rate is 115200 baud, CR+LF
|
|
|
|
```
|
|
AT+BAUD4
|
|
AT+NAMEINAV
|
|
```
|
|
|
|
The baud rate values:
|
|
| Value | Baud |
|
|
|------|------|
|
|
| 1 | 9600 |
|
|
| 2 | 19200 |
|
|
| 3 | 38400 |
|
|
| 4 | 115200 |
|
|
|
|
There are many counterfeits of the HC08/09 modules on the market, which work unreliably at high baud rates.
|
|
However, it is recommended to avoid these modules and to use an original HM-10.
|
|
|
|
### SpeedyBee adapter
|
|
|
|
Just connect it to the USB port, no further configuration needed.
|
|
|
|
## TCP and UDP
|
|
|
|
Allows connections via Wifi.
|
|
|
|
Hardware:
|
|
- DIY, ESP8266 based:
|
|
This project can be used to make INAV Wifi enabled: https://github.com/Scavanger/MSPWifiBridge
|
|
A small ESP01S module should still fit anywhere.
|
|
|
|
- ExpressLRS Wifi:
|
|
Should work (via TCP, port 5761), but untested due to lack of hardware from the developer. CLI and presets do not work here, problem in ELRS, not in INAV.
|