mirror of
https://github.com/iNavFlight/inav.git
synced 2025-07-13 03:19:58 +03:00
45 lines
1.7 KiB
Markdown
45 lines
1.7 KiB
Markdown
# ADS-B
|
|
|
|
[Automatic Dependent Surveillance Broadcast](https://en.wikipedia.org/wiki/Automatic_Dependent_Surveillance%E2%80%93Broadcast)
|
|
is an air traffic surveillance technology that enables aircraft to be accurately tracked by air traffic controllers and other pilots without the need for conventional radar.
|
|
|
|
## Current state
|
|
|
|
OSD can be configured to shows the closest aircraft.
|
|
|
|
## Hardware
|
|
|
|
All ADSB receivers which can send Mavlink [ADSB_VEHICLE](https://mavlink.io/en/messages/common.html#ADSB_VEHICLE) message are supported
|
|
|
|
* [PINGRX](https://uavionix.com/product/pingrx-pro/) (not tested)
|
|
* [TT-SC1](https://www.aerobits.pl/product/aero/) (tested)
|
|
* [ADSBee1090](https://pantsforbirds.com/adsbee-1090/) (tested)
|
|
|
|
## TT-SC1 settings
|
|
* download software for ADSB TT-SC1 from https://www.aerobits.pl/product/aero/ , file Micro_ADSB_App-vX.XX.X_win_setup.zip and install it
|
|
* connect your ADSB to FC, connect both RX and TX pins
|
|
* in INAV configurator ports TAB set telemetry MAVLINK, and baudrate 115200
|
|
* go to CLI in inav configurator and set serialpassthrough for port you connected ADSB ```serialpassthrough [PORT_YOU_SELECTED - 1] 115200 rxtx``` and close configurator
|
|
* open ADSB program you installed, got to settings and set "telemetry" = MAVLINK,
|
|
|
|
PCB board for TT-SC1-B module https://oshwlab.com/error414/adsb-power-board
|
|
|
|
|
|
## ADSBee 1090 settings
|
|
* connect to ADSBee1090 via USB and set COMMS_UART to mavlink2 \
|
|
``
|
|
AT+PROTOCOL=COMMS_UART,MAVLINK2
|
|
``\
|
|
``
|
|
AT+BAUDRATE=COMMS_UART,115200
|
|
``\
|
|
It's recommended to turn of wifi \
|
|
``
|
|
AT+ESP32_ENABLE=0
|
|
``\
|
|
``
|
|
AT+SETTINGS=SAVE
|
|
``
|
|
* in INAV configurator ports TAB set telemetry MAVLINK, and baudrate 115200
|
|
* https://pantsforbirds.com/adsbee-1090/quick-start/
|
|
|